The layout is a typical 65% keyboard but with a numpad on the left hand side. This design takes inspiration from the original EXT65 and uses the Rev 2 PCB by Xelus and Aeboards.
CASE PLATE IS NOT INCLUDED.
DOES NOT ACCEPT AEBOARD'S EXT65 PLATES
Plates are sold separately:
Purchase Futomei plates here.
Please add to your cart during checkout.
- Laser cut from 3mm acrylic
- Burger Mount (O-ring + bottom mounted plate)
- 7 degree typing angle
Case Includes:
- Acrylic Case - Satin top piece with clear middle acrylic pieces
- Satin acrylic feet - 4 pieces of acrylic
- Hardware - Screws, standoffs, bumpons, O-rings
-
EXT65 R2 PCB - USB Type C, Solder, RGB under-glow
(RRP of 110AUD)
Layout:
Disclaimer:
Not the same as the OpenSource Case File.
Keycaps, Switches, Stabs not included. Not compatible with MT3 Keycaps.
Do not clean with Isopropyl alcohol
Rinse or wipe the case with water or an electrostatic remover as there is a possibility of lingering static, which may damage your PCB.
A protective layer is still attached to the acrylic pieces and needs to be removed. Dust is easily attracted when removing this film, so I recommend having a damp microfiber cloth on-hand. BE CAUTIOUS FOR ESD.
May have some slight variation on the edges of each acrylic layer due to the nature of Laser Cutting, however great attention is given to ensure the straightest and most consistent edge alignment possible.