Holee/Epsilon/Band-Aid Mod All Made Simple
Each pre-cut Poron piece has a mild adhesive backing and can be carefully re-applied several times without leaving residue.
Pack Contains:
- 20x PCB Stab Housing Buffer Film 0.2mm (1)
- 20x PCB Stab Stem Buffer Film 0.2mm (2)(3)
- 20x PCB Stab Stem Buffer Film 0.3mm (4)
- 20x Stab Wire Silencing Foam 0.15mm (5)
- 20x Stab Wire Stabilising Film 1mm (6)
(1) PCB Stab Housing Film 0.2mm
Sits between the stabiliser housing and PCB. Allows the Stab housing to be gasket-ed to the PCB. The internal Poron is the same shape as item (3) and (4).
(2)(3) PCB Stab Stem Film 0.2mm
The base of the Stabiliser insert will contact this Poron Pad instead of the PCB. Replaces the Band-Aid Mod and can stack several depending on preferences.
Note: Too many Pads may prevent the switch from actuating/bottoming out. 2x Pads is the suggested.
(4) PCB Stab Stem Film 0.3mm
Slightly thicker variant of (3).
(5) Stab Wire Foam 0.15mm
Reduces the space inside the stabiliser insert minimising potential "wire ticking." Essentially the Holee or Epsilon Mod with a precut sized piece for a perfect fit.
(6) Stab Wire Film 1mm
The Stab wire rests on-top of this thick Poron slab. Mitigates rattle by limiting the vertical and horizontal movements of the wire. Several pads are required for long wires.
If the Stab Wire does not touch the 1mm Poron, add 1x 0.2mm Poron Piece underneath.
Disclaimer
Tweezers are necessary as the Poron is very small and installation is finicky.
Poron item(5) requires patience and may be difficult to position correctly.